First waco setup

[killjoyjim]

I am in the proces of picking out my waco part's.So far I have the Block it is a XSPC. Thank you Stan.
I also have #2 GTX470.With Danger Den Block's.& I have a Swifteck 220mm & 220mm danger Den Rad's
Thank's to kennyHa. I also have a Koolance 480mm 3-fpi copper rad.Thank's to Charleybwoy.
I will get the XS PC D5 Pump.Also koolance red tubing with red compression fitting's Koolance ram block.
So here is my loop.Let me know what you think.
From pump to cpu.cpu to 480mm rad out rad to ram block out ram block to gpu.out gpu's ro 220mm rad out 220mm rad to 80mm x 400 mm res.Out res to pump.
Be nice.My first waco setup.
And Thank you for you're input.

[killjoyjim]

No one?

[Deton]

didn't you already have a similar thread like this one and what kind of rad only have 3-fpi?

If I were you I don't bother use the dual rad and if I have to use then just use one instead of two. You need to calculate the heat load of your CPU and GPUs then incorporate the radiator accordingly to the heat load. You're overkill with your setup.

[killjoyjim]

ok Thank's denton

[Doctor_Death]

Was are you using old GPUs? the GTX470s are out dated.

[killjoyjim]

Becuse I got a good deal on them. And I am giving my gtx 580 to my son for his rig.

[Deliverance]

As long as your reservoir is directly before your pump, your loop order doesn't even matter. The temps will achieve a constant after a while.

[killjoyjim]

OK Thank you.That is what I was trying to find out.