Rigid Ghost Compression Fittings Knurled Grip - 4 Packs

[GEARjmr]

I think if you use Bits angle adapters with the Primochill Fittings you won't be too happy with the look as the fittings are larger than the angle fitting. The Fitting will install into the Bits adapters as both are G1/4 but I'd check outside diameter dimensions first.

[vinman]

I think if you use Bits angle adapters with the Primochill Fittings you won't be too happy with the look as the fittings are larger than the angle fitting. The Fitting will install into the Bits adapters as both are G1/4 but I'd check outside diameter dimensions first.

That is very good point you bring up thank you!

[AverageNinja]

I like the white and the silver ones!
The red and black ones also look good!

[Primochill]

So sorry for the Late reply Guys as i was on Vaction for almost 2 weeks but i am back now, As far as fittings with angles i am personally running EK angles with the Rigid Compressions Fittings and i also have run them using Bitspower angles on a test bench i have setup. So the answer is Yes,BUT as with any other mixing of fittings there is always a chance that a specific adapter or fitting from one brand might not work with another from another brand as i have found out the hard way in the past. Thread wise yes its a standard G1/4 Thread.

I hope this helps and again sorry i wasnt able to reply but trust me a vacation is not very often for me

Take Care My good Friends.

[velko]

Ok im witing for them to be availible in EU they are on my list

[GEARjmr]

Thanks Primo, I was hoping you could put up a pic of the Rigid Compression Fittings with the EK angle adapters, and the Bits if you still have 'em set up. Thanks!!

So sorry for the Late reply Guys as i was on Vaction for almost 2 weeks but i am back now, As far as fittings with angles i am personally running EK angles with the Rigid Compressions Fittings and i also have run them using Bitspower angles on a test bench i have setup. So the answer is Yes,BUT as with any other mixing of fittings there is always a chance that a specific adapter or fitting from one brand might not work with another from another brand as i have found out the hard way in the past. Thread wise yes its a standard G1/4 Thread.

I hope this helps and again sorry i wasnt able to reply but trust me a vacation is not very often for me

Take Care My good Friends.

[Primochill]

Thanks Primo, I was hoping you could put up a pic of the Rigid Compression Fittings with the EK angle adapters, and the Bits if you still have 'em set up. Thanks!!

I will as soon as i get a chance. Might not be till next week though as i only have the Prototypes here and they are not pretty like the production ones.But i do have some coming its just been hard keeping up with the demand. But like i said i will post a Photo as soon as a have Production fittings here.